RV enthusiasts get great satisfaction in having all the creature comforts of home â€” until something pops up, like a toilet thatâ€™s no longer holding water and is creating unpleasant odors inside the trailer. Replacing the waste ball or blade seal will usually put that smile back on their faces.
Some toilet models have a blade and a seal while most later-model toilets have a ball and a seal. Over time, constant use, grit, friction, toilet paper and hard water deposits take their toll on the seal and the ball (or blade) in the toilet.
If your toilet has a blade and seal, itâ€™s common to struggle with toilet paper that becomes lodged in the groove where the blade closes. A simple solution that works most of the time is to use a flat-bladed screwdriver bent at a 90-degree angle 1 inch from the tip. While holding the foot pedal down (water off), insert the tip of the screwdriver into the groove and dislodge the toilet paper. If this trick doesnâ€™t solve the issue, the blade and/or seal will need to be replaced. Use caution here; sharp objects, like a screwdriver, can damage the seal. Experienced techs have no problem with this, but if itâ€™s your first attempt, you might want to opt for a similar tool thatâ€™s made of plastic or nylon.
During the last several years, toilet manufacturers have been using the ball and seal to alleviate toilet paper buildup in the mechanism. And thatâ€™s the type of seal we replaced in a Thetford Style II toilet that was no longer holding water between flushes.
The process takes about 45 minutes and you will need a half-inch wrench and a tool to remove the water line from the back of the toilet. We also recommend having several old towels on hand â€¦ just in case!
After turning off the pump or closing the hookup faucet, release water pressure by holding down the foot pedal. Remove the decorative cover and disconnect the water line before using the half-inch wrench to remove the two nuts from the flange bolts that hold the toilet to the bathroom floor. Now would be a good time to place those old towels around the toilet to absorb the water that will inevitably escape from the water line once itâ€™s removed.
Lift the toilet from the floor and place it on a solid work surface that has been covered with a protective towel to guard against damage to the exterior of the toilet.
Remove the old closet flange seal. Then remove the four half-inch nuts that hold the porcelain bowl to the plastic base. Discard the four plastic washers under each nut. Separate the bowl from the base and you will see the seal lying directly on top of the ball. Remove and discard the seal and inspect the ball for any obvious scratches or gouges. Replace the ball if itâ€™s damaged to keep it from compromising the new seal.
Install the new Thetford waste ball seal with the flat side down. Add supplied grease to the underside of the bowl where it meets the seal.
Replace the bowl onto the base; loosely install the new plastic washers and half-inch nuts. Lift the toilet seat up and center the bowl onto the new seal. Finish by carefully tightening the nuts until they are snug, making sure the seal does not move. Do not over tighten or you will be buying a new toilet!
Reinstall the toilet in the RV with the new flange seal in place, reattach the water line, check for leaks, replace the decorative cover and youâ€™re done. The bowl seal should now hold water and help ward off any nasty fumes.
The Thetford Style II Waste Ball Seal Replacement Kit (part no. 34120) retails for $39.95 and includes everything youâ€™ll need.
Thetford Corporation, (734) 769-6000, www.thetford.com.