Intervac91011

[4] For this installation, an unused compartment at the floor was used to mount the vacuum housing and necessary hoses and fittings. [5] An accurate template is provided with the kit for determining the location of the fasteners that hold the vacuum housing in place. Here, the screws were driven through the paper. [6] Two 20-gauge wires are routed from each valve port to the yellow wires in the bottom of the vacuum housing.
[9] The inlet valve picks up power from the vacuum housing and when the flap is lifted for inserting the hose, the motor starts automatically. [10] The backing plate for the inlet valve provides a seal between the hose and plumbing to the vacuum housing. [11] Configuring the pipes requires the use of PVC cement to make necessary connections for routing the hoses from the vacuum housing to the inlet ports, including the VacPort.

Products

Class A motorhome with zip dee awning

Two-stage Convenience

Awnings by Zip Dee now offers the Century 2, a roof-mounted awning designed to add awning strength without overextending into neighboring RV sites. The...
King Combi step ladder

King Kombo

Considering the limited storage space in a motorhome, a conventional ladder may seem like a luxury item. But when that one item can perform...
ENSEN JWM45 Two-zone Stereo

JENSEN JWM45 Two-zone Stereo is Twice as Nice

Music is an important part of the motorhome lifestyle, inside and out of the coach. ASA Electronics now offers the JENSEN JWM45 Two-zone Stereo....
Dometic-PLB40-Portable-Li-battery

Dometic PLB40 Portable Lithium Battery

Perfect for off-grid camping, the Dometic PLB40 lithium battery was designed to run 12-volt DC appliances — specifically, Dometic’s line of CFX mobile compressor...
Photo of Oru folding kayak

Origami On the Water

Looking to ply the waters but don’t have the space to store a traditional kayak? Oru has launched its first tandem folding kayak, the...