IMG_0017

After the heating element is installed into the plenum, the plenum is installed to the rear of the furnace and high- temperature aluminum foil tape is used to seal the edges.
The orange, 10-gauge Romex runs between the J-box to the disconnect switch to the controller, then runs down to the heating element. The flexible heat ducting is attached to the plenum.

Products

Sponsored Content: REDARC BCDC Battery Chargers

New multistage chargers from REDARC use solar power for motorhome house batteries Need to keep your motorhome’s house batteries charged? REDARC’s Dual-Input BCDC in-vehicle battery...
Class A motorhome with zip dee awning

Two-stage Convenience

Awnings by Zip Dee now offers the Century 2, a roof-mounted awning designed to add awning strength without overextending into neighboring RV sites. The...
King Combi step ladder

King Kombo

Considering the limited storage space in a motorhome, a conventional ladder may seem like a luxury item. But when that one item can perform...
ENSEN JWM45 Two-zone Stereo

JENSEN JWM45 Two-zone Stereo is Twice as Nice

Music is an important part of the motorhome lifestyle, inside and out of the coach. ASA Electronics now offers the JENSEN JWM45 Two-zone Stereo....
Dometic-PLB40-Portable-Li-battery

Dometic PLB40 Portable Lithium Battery

Perfect for off-grid camping, the Dometic PLB40 lithium battery was designed to run 12-volt DC appliances — specifically, Dometic’s line of CFX mobile compressor...