DON_008_4892

7. First, slide the nut over one end of the hose followed by the ferrule. Then push the air line over the fitting on the main body of the union until it bottoms out. Pull the nut down over the ferrule and tighten with a wrench. Then repeat on the other end. Since the fitting seals on the inside between the ferrule and the hose, no thread sealant is required.
9. Since this large diameter fitting will now reside in a tray full of polymer air lines, it is important to cover it so that the brass union will not rub against the other air lines and cause additional leaks.

Products

Class A motorhome with zip dee awning

Two-stage Convenience

Awnings by Zip Dee now offers the Century 2, a roof-mounted awning designed to add awning strength without overextending into neighboring RV sites. The...
King Combi step ladder

King Kombo

Considering the limited storage space in a motorhome, a conventional ladder may seem like a luxury item. But when that one item can perform...
ENSEN JWM45 Two-zone Stereo

JENSEN JWM45 Two-zone Stereo is Twice as Nice

Music is an important part of the motorhome lifestyle, inside and out of the coach. ASA Electronics now offers the JENSEN JWM45 Two-zone Stereo....
Dometic-PLB40-Portable-Li-battery

Dometic PLB40 Portable Lithium Battery

Perfect for off-grid camping, the Dometic PLB40 lithium battery was designed to run 12-volt DC appliances — specifically, Dometic’s line of CFX mobile compressor...
Photo of Oru folding kayak

Origami On the Water

Looking to ply the waters but don’t have the space to store a traditional kayak? Oru has launched its first tandem folding kayak, the...